THE ANALYSIS OF TOOTH AREA CHARACTERISTIC INFLUENCE ON WORKING CHARACTERISTICS OF ASYNCHRONOUS MOTOR
Abstract
The proportions of asynchronous motor tooth area were calculated based on verifying computation. The motor working characteristics with varied combination of modified tooth area characteristic were calculated. The slot width and height of stator and rotor, the air-gap value were modified. The analysis of working characteristics, obtained after tooth area configuration changing, was produced. It was determined, that rotor lot proportions influence on working characteristics is the largest.
About the Authors
Valery Marmyshev
North-Caucasus Federal University
Russian Federation
Russian Federation
Irina Romanenko
North-Caucasus Federal University
Russian Federation
Russian Federation
Maksim Danilov
North-Caucasus Federal University
Russian Federation
Russian Federation
References
1. Романенко И. Г., Юдина О. И. Анализ влияния геометрии зубцовой зоны статора на рабочие характеристики погружного асинхронного двигателя // Вестник СКФУ 2015. № 5. С. 26-31.
2. Проектирование элетрических машин / под ред. И. П. Копылова. 3-е изд., испр. и доп. М.: Высш. шк., 2002. 757 с.
Review
For citations:
Marmyshev V., Romanenko I., Danilov M. THE ANALYSIS OF TOOTH AREA CHARACTERISTIC INFLUENCE ON WORKING CHARACTERISTICS OF ASYNCHRONOUS MOTOR. Newsletter of North-Caucasus Federal University. 2017;(2):16-21. (In Russ.)
Views:
133
Email this article 